cr1901_modern has quit [Read error: Connection reset by peer]
rohitksingh_work has joined #m-labs
<larsc>
just took two random boards, the difference in delay for the same IBUFDS_GTE2 seems to be 400ps
<larsc>
but that of course also includes all other delays like net delays
<whitequark>
sb0: back to rust runtime? or is there something else high-priority?
<sb0>
whitequark, yes, rust runtime
<sb0>
larsc, let me bother the white rabbit folks about this...
<sb0>
whitequark, you bought a fancy camera recently. does the same vendor offer a high-resolution, possibly low-framerate, monochrome camera with USB and linux support?
<sb0>
I actually need just a 1D CCD, but 2D ones are far more common
sandeepkr_ has joined #m-labs
sandeepkr__ has quit [Ping timeout: 265 seconds]
kuldeep has quit [Ping timeout: 244 seconds]
cr1901_modern has joined #m-labs
kuldeep has joined #m-labs
sandeepkr__ has joined #m-labs
sandeepkr_ has quit [Read error: No route to host]
sandeepkr_ has joined #m-labs
sandeepkr__ has quit [Ping timeout: 260 seconds]
<whitequark>
sb0: the vendor is casio
<whitequark>
I don't think they do... this camera definitely doesnt' support streaming over USB, for one
<whitequark>
sb0: I've seen a cheap 1D CCD recently, I can dig that up, it's orderable from RS IIRC
<whitequark>
you could probably interface that from an FPGA or something.
<sb0>
yes, a bare high-sensitivity 1D CCD is a few RMB on taobao. but then you have to mess around with a PCB, A/D converter, USB chip, etc.
<cr1901_modern>
I mean, I'd be willing to use it as my main schematic capture at this point, but asking if $SCHEM_CAP program sucks is kinda like asking if water's wet.
<mumptai>
did some hobbyist 2 and 4-layer stuff with it. interactive router is a step in the right direction, lib management is nonesens imho. am using altium in office, and eagle for hobby purposes for almost a decade. eagle is basically done, office stuff will remain altium
sandeepkr__ has joined #m-labs
sandeepkr__ has quit [Max SendQ exceeded]
kuldeep has quit [Ping timeout: 244 seconds]
sandeepkr_ has quit [Ping timeout: 265 seconds]
kuldeep has joined #m-labs
<rjo>
bb-m-labs: force build --props=package=artiq-pipistrello-nist_qc1 --branch=release-2 artiq-board
<bb-m-labs>
build forced [ETA 15m34s]
<bb-m-labs>
I'll give a shout when the build finishes
rohitksingh_work has quit [Read error: Connection reset by peer]
sandeepkr has joined #m-labs
<GitHub74>
[artiq] jordens pushed 1 new commit to release-1: https://git.io/violT