<azonenberg>
What does it mean when a face is outlined in red?
<whitequark>
azonenberg: outlined? that means bare edges
<whitequark>
basically, the mesh operation has failed
<whitequark>
solutions are (rarely) to decrease chord tolerance, (usually) to bring the part slightly off symmetry. E.g. if you try to lathe a sphere and then add a cylinder thru it the NURBS backend will break
<whitequark>
but you can make it work by making the cylinder very slightly off center
<whitequark>
I know this is crap, but I do not even know anyone with the right knowledge to fix this, much less the (what I assume aree) required funds
<azonenberg>
Hmm, interesting
<azonenberg>
Yeah so looks like i had two collinear lines that met at the end
<azonenberg>
i think that if i merge them it might work
<cr1901_modern>
bare edges?
<whitequark>
erm
<whitequark>
naked edges
cr1901_modern1 has joined #solvespace
cr1901_modern has quit [Ping timeout: 240 seconds]