04:00 <micolous> mdrjr: I hear you're a good person to ask about the board design of the ODroid

04:00 <micolous> hello!

04:00 <micolous> I have an odroid U3 Revision 2, according to the schematic there's supposed to be a 0 Ohm resistor at R39

04:01 <micolous> But it's not present on my board

04:01 <micolous> On the Revision 5 schematic, this is crossed out

04:01 <micolous> From my (vague) understanding of it, bridging this point will allow the unit to be powered up from the microusb socket

04:01 <micolous> Would this be correct?

04:02 <micolous> I'm not looking to use the port for OTG or anything like that... just I've lost the barrel-jack to USB cable I built and was looking for a better way to power it up

04:02 <micolous> At the moment I have a couple of wires going in to pins 7 and 8 of the IO expansion port

04:03 <micolous> But this doesn't fit in the case cleanly

04:44 <si1v3r> That sounds like a similar raspberry pi issue

04:45 <si1v3r> You could test for continuity between where you want to put power and where you know power will be needed to confirm it's safe.

05:03 <micolous> Hmmm... that's a thought