return0xe has quit [Read error: Connection reset by peer]
return0e has joined #linux-rockchip
return0xe has joined #linux-rockchip
return0e has quit [Ping timeout: 244 seconds]
Tef613 has quit [Ping timeout: 246 seconds]
ldevulder_ has joined #linux-rockchip
ldevulder_ is now known as ldevulder_vacati
LargePrime has quit [Ping timeout: 245 seconds]
LargePrime has joined #linux-rockchip
<nashpa>
hi, anyone has a suggestion on how I can figure out the GPIO pin that is used to receive the RK808 pmic_int_l signal on a K99 TV-BOX system?
<nashpa>
I've wiped the old firmware before making a note of /proc/interrupts and now I can boot mainline U-Boot+ATF+kernel, but the interrupt that got copied from rk3399-firefly.dts gets disabled by the kernel because "nobody cared" (i.e. pin wiggled but the RK808 status registers did not change)
afaerber has quit [Quit: Leaving]
JohnDoe_71Rus has joined #linux-rockchip
<Ke>
well, obviously someone is scheduling while atomic in mwifiex
<Ke>
in -rc8
_whitelogger has joined #linux-rockchip
lerc has quit [Ping timeout: 276 seconds]
lerc has joined #linux-rockchip
<Ke>
and not even a complicated one
<Ke>
hmm according to git log no new changes, but this code is obviously wrong as far as I can tell
JohnDoe_71Rus has quit [Ping timeout: 245 seconds]
stikonas has joined #linux-rockchip
berton[m] has joined #linux-rockchip
anarsoul|2 has joined #linux-rockchip
stikonas has quit [Read error: Connection reset by peer]
stikonas_ has joined #linux-rockchip
tlwoerner has quit [Ping timeout: 252 seconds]
tlwoerner has joined #linux-rockchip
afaerber has quit [Quit: Leaving]
afaerber has joined #linux-rockchip
stikonas_ has quit [Read error: Connection reset by peer]
stikonas has joined #linux-rockchip
return0xe has quit [Read error: Connection reset by peer]
LargePrime has quit [Ping timeout: 246 seconds]
LargePrime has joined #linux-rockchip
return0e has joined #linux-rockchip
VargaD has joined #linux-rockchip
VargaD has quit [Read error: Connection reset by peer]